This installation must comply with all applicable
state and local regulations.
Use only Teflon
®
tape without adhesive backing to
seal joints. Do not use pipe compound (pipe dope),
sticks, or similar compounds; they contain
petroleum derivatives which will cause crazing
and cracking of the plastic in the filter housing.
Use only soap and water to clean filter housing
and components.
Do not use aerosol sprays (bug spray, cleaning
fluids, etc.) near the filter. They contain organic
solvents which will cause crazing and cracking of
the plastic in the filter housing.
After prolonged periods of non-use, such as a
vacation, it is recommended that the system be
flushed thoroughly. Let water run for 5-6 minutes
before using.
Wear safety glasses during installation.
Installation Instruction
Suggested Installation of BIG BLUE20
The recommended installation has a shut-off valve on the
inlet side of the filter. The installation had shown uses PVC
piping.
To Next Page
Loading...
