Troubleshooting
Leaks between cap and bottom of housing:
1. Turn off water supply and depress pressure-relief
button.
2. Clean and lubricate O-ring with silicone grease.
Also, clean the groove where the O-ring seats with
a clean cloth. Replace O-ring back in groove
above threads. Screw bottom of housing back on
cap securely by hand (DO NOT OVER
TIGHTEN).
3. Turn on water supply. If leaks persist, or if there
are other leaks on the system, turn off water
supply. Call Pen K’s service department.
Leaks on inlet/ outlet connections:
1. Turn off water supply. For brass fittings, tighten
nut 1/2 – turn with wrench.
2. Turn on water supply. If leaks persist, or if there
are other leaks on the system, turn off water
supply. Call Pen K’s service department.
Replacement Parts
1. BIG BLUE20 Cap, 1 – inch HEPP blue with
pressure – relief
2. BIG BLUE20 heavy duty housing
3. O-ring
4. Silicone
5. Cartridge
6. Wrench SW-4
7. Mounting Bracket included 8 units of screw
To Next Page
Loading...
