Pentair EVERPURE H Series - Installation Instructions - English; Tools Needed for Installation; Open Carton & Inspect Parts; Verify Under-Sink Mounting Location

ENGLISH
4 • EVERPURE
®
H-Series Water Filtration Systems
BASIC INSTALLATION INSTRUCTIONS
Tools Needed For Installation
• Phillips Screwdriver • Wrench • Pencil
• Utility Knife • Measuring Tape
1. OPEN CARTON & INSPECT PARTS
Installation Parts
Key Description Part No.
1 QL3 Filter Head EV925831
2 Filter Cartridge (varies)
3 2 Locking Washers EV306204
4 2 Screws EV306196
5 Angle Stop Valve Adaptor EV312120
6 Tubing, 1/4" poly A0860119
7
Elbow Fitting Pack Restrictor EV308168
8 Plumbers Tape EV312119
9 Faucet Connector EV312135
10 Everpure Filter Timer EV314160
2. VERIFY UNDERSINK MOUNTING LOCATION
Measure 22” from the base of the cabinet, and mark the
mounting location for the top of the filter head. Make sure
there is adequate space above the head to open and close
the built in shut-off valve and to avoid crimping the water
line tubing. Also, make sure your chosen location offers
easy access for future cartridge changes.
DIMENSION Width Height Depth
H-54 5" 15" 5"
H-104 5" 20" 5"
H-300 5" 22" 5"
H-300-HSD 5" 22" 5"
H-300-NXT 5" 22" 5"
NOTE:
The head and cartridge must be mounted in the
vertical position, with the cartridge hanging down.
1
1
2
3
5
6
7
8
9
10
4
2
22"