ENGLISH
6 • EVERPURE
®
H-Series Water Filtration Systems
1
1
2
3
5
6
7
8
9
10
11
12
4
Q
R
S
T
Label
Lug
U
X
6
V W
Y
6. INSTALL AND FLUSH FILTER CARTRIDGE
Q. Lift handle of the built-in shut off (QC Valve) on the
Head.
R. Hold Head firmly with one hand.
S. Align cartridge lug with label on filter Head.
T. Insert filter Cartridge – Push upwards.
U. Turn it to the right – About 1⁄4 turn – Until rotation
stops.
V. Open Side Valve of Angle Stop Adaptor and check
for leaks up to Inlet Elbow Fitting.
W. Open Filtered Water Faucet.
X. Lower the QC Valve Handle to flush water to the
sink.
NOTE:
Flush new filter cartridges for at least
3 minutes (flush H-1200 system for at least 7
minutes) to remove air and any loose carbon. At
first the water may appear cloudy due to trapped
air in the filter and tubing. If water continues to
be cloudy for more than one week, please contact
Everpure Technical Services for assistance.
Y. Activate Filter Timer by pinching bubble until you
feel a change in resistance as the Filter timer
“pops”. Within a few seconds, a thin RED line will
appear in the white window showing the Timestrip
®
has been activated. Peel away backing and adhere
to desired location. When the white window is
completely filled with RED, it is time to replace your
product.
H1200 INSTRUCTIONS
Tools Needed For Installation
• Phillips Screwdriver
• Wrench
• Utility Knife
• Measuring Tape
• Pencil
1. OPEN CARTON & INSPECT PARTS
Installation Parts
Key Description Part No.
1 QL Twin Series Filter Head EV927222
2 Filter Cartridges (Set of 2) EV928201
3 2 Locking Washers EV306204
4 2 Screws EV306196
5 Angle Stop Valve Adaptor EV312120
6 Tubing, 1/4" poly A0860119
7 Elbow Fitting Pack
Restrictor
EV308168
8 Plumbers Tape EV312119
9 Faucet Connector EV312135
10 Everpure Filter Timer EV314160
11 Shut Off Valve,
3/8" John Guest
®
x 3/8" FPT
EV309860
12 Coupler, 3/8" FPT
Stainless
EV312350
To Next Page
Loading...
