Why is Pentair Control Unit losing mineral through drain line?
If you're experiencing a loss of mineral through the drain line of your Pentair Control Unit, it could be due to air in the water system; ensure that the well system has a proper air eliminator control and check for a dry well condition. Alternatively, the drain line flow control might be improperly sized; check for the proper drain rate.
How to remove iron from conditioned water of Pentair Control Unit?
If there's iron in the conditioned water from your Pentair Control Unit, it could be due to a fouled mineral bed. Check the backwash, brine draw, and brine tank fill. Increase the frequency of regeneration and the backwash time.
Why is my Pentair Control Unit cycling continuously?
If your Pentair Control Unit cycles continuously, it could be due to a misadjusted, broken, or shorted switch. Determine if the switch or timer is faulty and replace it, or replace the complete power head.
General| Timer Type | Mechanical |
|---|---|
| Valve Material | Noryl |
| Power Supply | 120V |
| Mounting | Top Mount |
| Materials | Noryl |
| Drain Line | 1/2 inch |
| Distributor Pilot | 1.05 inch |
| Salt Storage | Not applicable (external brine tank) |
| Application | Water Softener/Filter |
| Connection Size | 1 inch NPT |
| Inlet/Outlet | 1 inch NPT |
Step-by-step guide for installing the water softener unit.
Guide to setting up the water softener after installation for initial operation.
Procedure to configure daily regeneration schedules and set the time of day.
Guide to setting the current time and manually starting the regeneration process.
Guide to diagnosing and correcting issues like regeneration failure, hard water, and leaks.
To Next Page