Pentair Fleck 5600-MECH - Description and components location; By-passing; Programming; Basic programming

User Guide Fleck 5600-MECH
6 / 36 Ref. MKT-UG-053 / B - 16.01.2023
3.3. Description and components location
3.4. By-passing
If the system is equipped with a bypass and if a problem occurs, turn the valves to bypass the system as shown in the picture
below.
4 . Programming
Note: The controller don’t need to be plugged to be programmed.
4.1. Basic programming
Time of day
A Press the clutch (1).
B Turn the hour wheel (2) to display the correct hour in the window (3).







Inlet
Program wheel
Meter
Outlet
Drain
Brine
24h wheel
Mixing device
In Bypass
Out OutIn In
Softening System
Normal operation
Softening System
Fleck_5600-MECH_UG_VV_Multilingual.book Page 6 Mardi, 11. avril 2023 3:37 15