Pentair FLECK 5600SXT - Page 11

4. Press the Up button. Use this display to view the Hours
in Service since the last regeneration cycle. This option
setting is identified by “HR” in the upper left hand corner
of the screen.
5. Press the Up button. Use this display to view the Volume
Used since the last regeneration cycle. This option setting
is identified by “VU” in the upper left hand corner
of the screen.
6. Press the Up button. Use this display to view the Reserve
Capacity. This option setting is identified by “RC” in the
upper left hand corner of the screen.
7. Press the Up button. Use this display to view the Software
Version. This option setting is identified by “SV” in the
upper left hand corner of the screen.
8. Press the Extra Cycle button to end Diagnostic
Programming Mode.
DIAGNOSTIC PROGRAMMING MODE
CONTINUED
FLECK 5600SXT Downflow Service Manual • 11