Pentair FLECK 5600SXT - Job Specification Sheet

TABLE OF CONTENTS
JOB SPECIFICATION SHEET ...............................................2
INSTALLATION .....................................................................3
START-UP INSTRUCTIONS..................................................3
TIMER FEATURES ................................................................4
TIMER OPERATION .............................................................. 5
MASTER PROGRAMMING MODE CHART ............................6
MASTER PROGRAMMING MODE .........................................7
USER PROGRAMMING MODE............................................10
DIAGNOSTIC PROGRAMMING MODE ................................ 10
CONTROL VALVE ASSEMBLY ............................................ 12
VALVE POWERHEAD ASSEMBLY ......................................14
3/4-INCH TURBINE METER ASSEMBLY ..........................15
3/4-INCH PLASTIC PADDLE METER ASSEMBLY .............15
BYPASS VALVE ASSEMBLY (PLASTIC) ..............................16
BYPASS VALVE ASSEMBLY (METAL) ................................17
2300 SAFETY BRINE VALVE ..............................................18
2310 SAFETY BRINE VALVE .............................................19
TROUBLESHOOTING ..........................................................20
WATER CONDITIONER FLOW DIAGRAMS .........................22
WIRING DIAGRAM ..............................................................23
SERVICE INSTRUCTIONS ..................................................24
FLOW DATA & INJECTOR DRAW RATES ..........................26
SERVICE ASSEMBLIES ......................................................27
JOB SPECIFICATION SHEET
Job Number: ______________________________________________
Model Number: ____________________________________________
Water Hardness: __________________________________ ppm or gpg
Capacity Per Unit: __________________________________________
Mineral Tank Size: ___________ Diameter: ________Height: ________
Salt Setting per Regeneration: ________________________________
1. Type of Timer:
A. Time Clock
B. Meter Initiated
2. Downflow: Upflow Upflow Variable
3. Meter Size:
A. 3/4-inch Turbine
B. 3/4-inch Paddle Wheel
C. Electronic ____Pulse Count ___ Meter Size ____________
4. System Type:
A. System #4: 1 Tank, 1 Meter, Immediate, or
Delayed Regeneration
B. System #4: Time Clock
5. Timer Program Settings:
A. Backwash: ______________________________ Minutes
B. Brine and Slow Rinse:_____________________ Minutes
C. Rapid Rinse: ____________________________ Minutes
D. Brine Tank Refill: ________________________ Minutes
E. Pause Time: ____________________________ Minutes
F. Second Backwash: _______________________ Minutes
6. Drain Line Flow Control: gpm
7. Brine Line Flow Controller: gpm
8. Injector Size#:
CALIFORNIA PROPOSITION 65 WARNING
WARNING:
This product contains chemicals known to
the State of California to cause cancer or
birth defects or other reproductive harm.
2 • FLECK
5600SXT Downflow Service Manual