User Guide Fleck 5800-XTRi-XTR-SXT-LXT
12 / 76 Ref. MKT-UG-054 / A - 03.06.2022
5.4. LXT controller
5.4.1. Recommendations
• Use only regenerate salts designed for water softening EN973;
• for optimal system operation, the use of clean salt free from impurities is recommended (for example salt pellets);
• do not use ice melt, block, or rock salts;
• the sanitizing process (both with liquid and electrochlorination) introduces chlorine elements which may reduce the lifetime
of the ion exchange resins. Refer to the technical guides for resins in common use, providing necessary checks on the
system.
5.4.2. Manual immediate regeneration
A Press and hold for 5 seconds.
6 . Error codes
6.1. XTRi & XTR controller
Displayed when an alarm has occurred; accompanied with an audible alarm. Press to silence the audible alarm.
Displayed when an error has occurred. Press to display the error screen for more detailed error information.
6.2. SXT controller
The following error codes may be displayed during operation:
6.3. LXT controller
The following error codes may be displayed during operation:
7 . Maintenance
Mandatory: Cleaning and maintenance shall take place at regular intervals in order to guarantee the proper
functioning of the complete system, and be documented in the Maintenance record book.
Mandatory: The maintenance and service operation must be done by qualified personnel only. Failure in respecting this
may void the warranty.
8 . Troubleshooting
Please follow this procedure for any technical support:
A Collect the required information for a technical assistance request.
→ Product identification (see 2.1. Serial label location, page 5 and Original settings, page 2).
B Contact your local dealer who installed this device (see contact details on last page).
→ Also call him if the water tastes salty, if the water is not softened or if there is no salt consumption.
---0 Cam sense error: Unplug the unit and plug it back. If error continue, call technical support.
---1 Cycle sense error: Unplug the unit and plug it back. If error continue, call technical support.
---2 Regen failure: Perform a manual regeneration. If error continue, call technical support.
---3 Memory error: Call technical support.
---4 Fail safe error: Unplug the unit and plug it back. If error continue, call technical support.
---0 Cam sense error: Unplug the unit and plug it back. If error continue, call technical support.
---1 Cycle sense error: Unplug the unit and plug it back. If error continue, call technical support.
--- 2 Regen failure: Perform a manual regeneration. If error continue, call technical support.
---4 Fail safe error: Unplug the unit and plug it back. If error continue, call technical support.
Fleck_5800-XTR2_UG_VV_Multilingual.book Page 12 Mardi, 12. juillet 2022 10:34 10
To Next Page
Loading...
