Pentair FLECK 5800 SXT - By-passing; Programming; XTRi & XTR controller

User Guide Fleck 5800-XTRi-XTR-SXT-LXT
Ref. MKT-UG-054 / A - 03.06.2022 7 / 76
EN
3.4. By-passing
If the system is equipped with a bypass and if a problem occurs, turn the valves to bypass the system as shown in the picture
below.
3.5. XTRi controller installation requirements
• A 2.4 GHz WiFi connection is needed.
• A stable and sufficient WiFi signal is essential.
4 . Programming
4.1. XTRi & XTR controller
Note: Press on any Quick Start screen to reset the screen back to its default settings.
4.1.1. Touchscreen controller quick start
Note: If the screen is blank after plugging in the unit, touch the screen to turn the screen on.
Format screen
Press the
language button and use the arrows to adjust the system's
displayed language: English, French, German, Italian, Spanish, Dutch or
Portuguese.
•Press the
units button to adjust the system's units of measure (either U.S.
or metric);
• press the
hardness units button to adjust the system's hardness units of
measure (grains per gallon, mg/L or ppm, German degrees, French
degrees, or English degrees). Hardness units are adjustable only if metric
units are selected.
In Bypass
Out OutIn In
Softening System
Normal operation
Softening System
Format
units
hardness units
english
metric
mg/L
language
Fleck_5800-XTR2_UG_VV_Multilingual.book Page 7 Mardi, 12. juillet 2022 10:34 10