User Guide Foleo
12 / 116 Ref. MKT-UG-038 / D - 15.11.2019
5 . Programming
5.1. Home screen & commands
Note
If no button is pushed for five minutes, the screen will enter a power save mode. The unit will continue
to operate, but the screen will be blank. Touch anywhere on the screen to exit power save mode.
Note
Not all buttons appear on all screens.
1. Regeneration
→ Displays the regeneration screen, which allows you to start a regeneration and manually
cycle through the regeneration steps.
2.
Settings → Displays the settings screen, which allows you to adjust commonly used settings.
Pressing this button while in the settings screen provides access to the master settings
screen, which allows you to fully program the valve.
3. Diagnostics
→ Displays the diagnostics screen, which can assist in performing maintenance and
troubleshooting performance issues with the valve.
4. Assistance
→ Displays a name and phone number to call for unit service.
5. Vacation
→ Halts all scheduled regenerations when pressed; press again to resume normal
operation.
6. Regeneration
cycle wheel
→ Displays the cycle steps the valve will step through during service and regeneration; the
current cycle step is always shown on green.
Note
On metered units, the "Treatment" step on the regeneration cycle wheel will flash when water is
flowing through the unit.
Water Treatment
wed
12:01 am
4.5
m
3
treatment
tank refill
pause
rapid rinse
backwash
draw
To Next Page
Loading...
