PROGRAM
RESE T O F F/O N/ OF F/ON/ OF F/ ON/ O F F/ ON
Resets Light E ngine to
Random mode and turns on
the thumper.
Flashes Light 5 times
SOL ENOID
THUMPER
O F F/O N/ OF F/ON/ OF F/ ON
Turns solenoid “thumper” ON
or O F F
Flashes Light 4 times
LOCK C OL OR O F F/O N
Locks on any selected color.
Returns to previous color
change mode.
Color is fixed
Sync Mode - Colors will change at about 10 sec. intervals. In this mode, multiple Laminars will change colors together . If the
solenoid thumper mode is turned on, the thumpers on multiple Laminars will thump together.
Random Mode - Colors will change at about 10 sec. intervals but in a completely random sequence. In this mode, multiple
Laminars will N O T change colors together. If the solenoid thumper mode is turned on, the thumpers will thump at random intervals
and multiple Laminars will N O T thump together.
Party Mode - Colors will change randomly and slowly at first, then speed up, until the sequence ends with quick flashes and strobes.
Then the sequence starts again with slow changes. In this mode, multiple Laminars will N O T change colors together. If the sol e noid
thumper mode is turned on, t he thumpers will thump at random intervals and multiple laminars will N OT thump together.
LE D LIG HT
C OLO R
CHA NG E
O F F/O N/ O F F/ ON
Swi tches from one color
change mode to next. After a
Reset, R andom mode is
runnin
g
.
Sync Mode–1 flash
Random Mode–2 flashes
Party Mode–3 flashes
Start programming with the LED light engine ON. Change programs and modes by cycling the power ON and OFF rapidly
(1 Sec). Wait 10 seconds between MODE changes.
COLOR CHANGE MODE DESCRIPTION
Solenoid Thumper
The solenoid thumper feature cre ates a “wrinkle” in the laminar stream, which cre ates a br illiant spot of light in the laminar arc.
Cycle the power O F F/ON 3 times to turn the sol enoid thumper O N and OF F.
In Sync Mode it thumps every 2 seconds. In R andom and P arty mode it thumps randomly every 1 to 3.5 seconds.
Reset
When you select the reset fe ature, the LED light engine reverts to the Random color changi ng mode with the solenoid thumper ON.
Cycle the power OFF/ON 4 times to reset the LED light engine. The lights will flash 5 times, and then turn on in Random Mode with
the thumper on.
NOTE: In the event of a power interruption or power loss and the units become out of sequence, turn the light switch on and then
off four times (Off/On, Off/On, Off/On, Off/On). The unit will flash five (5) times then reset all of the lights and start them in Random
Mode with the thumper on.
/MODE
POWER CYCLE DESCRIPTION INDICATION
To Next Page
Loading...
