MAGICSTREAM
®
Laminar Installation and User’s Guide MAGICSTREAM
®
Laminar Installation and User’s Guide
11
The following describes how to install the MagicStream
®
Laminar.
INSTALLING MAGICSTREAM
®
LAMINAR
(NEW POOL CONSTRUCTION)
1. Dig a hole measuring 24” deep and 24” square and place the deck
housing in it. This will allow enough room to connect the supply piping
and electrical conduit.
2. Solvent weld the conduit and the drain and supply piping to the deck
housing.
3. Anchor the deck housing so that the top of the housing cover collar is at
the level of the finished deck (Figure 1). The adjustable collar should be
angled so that it will align flush with the finished deck surface. Once you
have made the final adjustments to the collar’s angle, glue the collar to
the deck housing.
4. Backfill around the deck housing with gravel to further stabilize the
housing during deck placement. Leave cover in place during deck
installation.
Note: The deck housing is made of ABS. Use a name brand ABS-PVC
cement to glue Sch40 PVC.
Mechanical Installation
Angle the adjustable housing cover collar
so that it aligns flush with the finished
deck surface, then glue in place.
Housing cover collar
Level of finished deck surface
Deck housing
Figure 1.
To Next Page
Loading...
