MAGICSTREAM
®
Laminar Installation and User’s Guide MAGICSTREAM
®
Laminar Installation and User’s Guide
6
Selecting Color Show Mode or a Fixed Color using a Wall
Switch
MagicStream Laminars are compatible with IntelliBrite light colors and shows and can be
synchronized with IntelliBrite color lights. First switch power on to the light; the previously
selected color show mode or fixed color is displayed. To select a color show mode (1-7)
or fixed color (8-12), rapidly turn the wall switch Off/On a specific number of times. Each
number (1-17) shown below corresponds to the number of times to power-cycle the switch
to activate a color light show or fixed color. For details about saving color effects while in
Show modes, see “Hold” and “Recall” feature on
page 10.
1
SAm Mode: Cycles through white, magenta, blue and green colors
(emulates the Pentair SAm® Color Light).
2 Party Mode: Rapid color changing building energy and excitement.
3 Romance Mode: Slow color transitions creating a mesmerizing and
calming effect.
4 Caribbean Mode: Transitions between a variety of blues and greens.
5 American Mode: Patriotic red, white and blue transition.
6 California Sunset Mode: Dramatic transitions of orange, red and
magenta tones.
7 Royal Mode: Richer, deeper color tones.
8 Blue: Fixed color.
9 Green: Fixed color.
10 Red: Fixed color.
11 White: Fixed color.
12 Magenta: Fixed color.
13 Hold: Save the current color effect during a color light show.
14 Recall: Activate the last saved color effect.
15 White
16 Standard Mode
17 IntelliBrite Mode
MagicStream Laminars can be controlled using a standard wall-mount light switch or by
the IntelliBrite
®
Controller (see page 10). Multiple MagicStream laminars can be connect-
ed via a junction box and 12 VAC transformer to a single switch so that all lights can be
switched on and off together. MagicStream laminars are controlled by cycling AC power
to the 12 VAC transformer from a standard wall switch. By turning the switch Off and On
a specific number of times, the light activates one of the seven light show modes, fixed
colors, or enables the “Hold” and “Recall” feature, see page 10.
Note: Wall switch must be connected to the 120 VAC side of the transformer and
never to the 12 VAC side.
Powering on the MagicStream Laminar
When the MagicStream laminar is powered on, the previously selected color show mode
or fixed color is displayed.
Note: If power to the light is off for more than five (5) seconds, the last color show mode or
fixed color that was saved will be displayed.
Operating MagicStream
®
Laminars Using a Wall Switch
Number of times to cycle power (1-17)
To Next Page
Loading...
