MAGICSTREAM
®
Laminar Installation and User’s Guide MAGICSTREAM
®
Laminar Installation and User’s Guide
10
Instead of using a wall switch, MagicStream
®
Laminars can controlled with the IntelliBrite
Controller (P/N 600054, sold separately). The
IntelliBrite controller provides complete control of
your MagicStream laminars when in IntelliBrite
Mode. The IntelliBrite controller can control
individual or multiple 12 VAC transformers
to control MagicStream laminars. Multiple
MagicStream laminars can be connected via a
junction box to the Controller so that all lights can
be switched on and off together. The IntelliBrite
controller can also control multiple MagicStream
laminars and IntelliBrite lights.
Selecting a MagicStream
®
Laminar show mode or fixed color
using an IntelliBrite
®
Controller
PRINTED ON: 7/29/2009, 600054_ctlg pics.SLDASM
Using the IntelliBrite Controller: MagicStream laminars are compatible with IntelliBrite
colors and shows and can be synchronized with IntelliBrite color pool/spa and landscape
lights. To select a color light show mode or fixed color mode, rotate the dial so that it points
to the desired selection. The color mode selections start in a clockwise direction from the
9 o’clock position.
Hold and Recall Feature
Note: When MagicStream laminars are powered on, the previously selected color show
mode or fixed color is displayed.
Hold button/LED: Press this button (LED on) to capture and save a color effect while
displaying one of the light show modes. When the button is pressed, the LED will be on,
indicating that the color effect is captured.
Recall Button/LED: Use this button (LED on) to activate the last saved color effect. When
the button is pressed, the LED will be on, indicating that the color effect is being displayed.
Activating IntelliBrite Random Mode: To toggle IntelliBrite Random Mode On or Off you
need to enter Party Mode, wait until the lights come on turn the dial one notch and then
enter Party Mode a second time with less than 30 seconds between them.
Activating Solenoid Thumper: The solenoid thumper feature creates a “wrinkle” in the
laminar stream creating a brilliant spot of light in the laminar arc. Toggle the Thumper On
or Off by entering Party Mode 3 times in less than 30 seconds. For example, turn the dial
to Party Mode, wait until the lights come on, turn the dial one notch and then back to Party
Mode and repeat a third time within 30 seconds.
Resetting All Lights: To Reset all the lights you need to enter Party Mode four (4) times
with less than 30 seconds between them. This will turn IntelliBrite Random Mode OFF. This
is needed because should two lights ever get into different states, toggling their states will
never fix the problem.
There are two ways to issue the commands with an IntelliBrite controller. You can switch
to Party Mode and then turn the lights on and off using the Green button the desired
number of times or you can switch back and forth between Party Mode and Sam Mode the
desired number of times. Both methods require you to wait until the lights come back on
before repeating the procedure. If the lights are not within sight of the controller, waiting 10
seconds between each change also works.
IntelliBrite
®
Controller
To Next Page
Loading...
