MAGICSTREAM
®
Laminar Installation and User’s Guide MAGICSTREAM
®
Laminar Installation and User’s Guide
21
CONNECTING MAGICSTREAM
®
LAMINAR TO AN
INTELLIBRITE
®
CONTROLLER
12 VAC MagicStream laminar and IntelliBrite Lights
IMPORTANT! When installing 12 VAC MagicStream
laminar, connect the lights to the
secondary 12 VAC output of the safety isolation (step down) transformer, then connect
the IntelliBrite controller to the 120 VAC primary input of the step down transformer.
RISK OF ELECTRICAL SHOCK OR ELECTROCUTION
TURN power OFF at circuit breaker -
Always disconnect power to the pool light at the circuit
breaker before servicing the light. Failure to do so could
result in death or serious injury to installer, service person,
pool users, or others due to electrical shock.
To wire multiple 12 Volt MagicStream
®
Laminar to an IntelliBrite Controller:
1. Neatly arrange the wires in the back of the outlet box.
2. Align the controller with the screw holes of the outlet box. Secure the controller to
the outlet box with the two (2) retaining screws.
3. Close the front door of the controller.
Installing the IntelliBrite Controller in the Outlet box
The IntelliBrite Controller mounts onto a standard outlet box (22.5 cubic inches minimum).
After wiring the IntelliBrite Controller, check all wiring connections before mounting the
controller into the outlet box.
To install the IntelliBrite Controller:
Arrange
wires neatly
behind
Controller
PRINTED ON: 7/29/2009, 600054_ctlg pics.SLDASM
Retaining
Screw
Screw hole
Screw hole
Retaining Screws
Retaining
Screw
IntelliBrite Controller
®
To Next Page
Loading...
