30
Pressing < > key for 1s switches the view mode
from temperature view to time view.
Exceptions :
• During "First warming" function, the temperature
view is replaced by "First warming" elapse time
counter view.
• During learning function, the temperature view is
replaced by setting temperature value. Pressing
<
> allows the user to view the elapsed learning
period for a duration of 3 seconds.
6.3. Installers's menu
Changing various standard settings of the
thermostat.
To enter following menus push and hold the
<
> button for 6 sec. Use the < > button
to step through the menu’s.
Menu 1: Sensor mode
The sensor mode is detected and
initialised automatically. If the floor
sensor cable is connected, it operates
in floor sensor mode <
>.
Menu 1: Sensor regulation choice
If no external sensor is attached the
thermostat works with room sensor
only and the user may not change it.
If an external sensor is attached, the user is allowed
to choose between 2 regulation modes :
1. Floor sensor only 2. Room with
floor limitation
To change the operating mode to room sensing with
floor sensor as limiter, press the
< >
buttons
until <
> is displayed.
Confirm by pressing < >.
If the floor sensor is not detected, it operates in room
sensing mode <
>.
To Next Page
Loading...
