EasyManuals Logo

Pentair OMNIFILTER OM26K User Manual

Pentair OMNIFILTER OM26K
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
PERFORMANCE DATA SHEET
Model OM26K
Maximum Rated Service
Flow (gpm) (W/upper
collector)
8
Pressure Drop at Rated
Service Flow Rate (gpm)
14
Rated Capacity
(grains @ lbs of salt)
11,902 @ 2.7
27,149 @ 13.1
Rated Efciency
(grains/lb Salt @ lb of salt)
4,400 @ 2.7 lbs
Maximum Flow Rate During
Regeneration (gpm)
1.7
Resin Volume per tank - ft
3
Resin Type - Strong Acid
Cation
0.82 ft
3
per tank
Tank size 8" x 44"
Operating Pressure:20 -125 psi or 1.4 – 8.8 kg/Centimeter
2
, Operating Temperature: 34 - 110° F or 1.1 43.3° C
Acceptable Salt Type: Sodium Chloride
All Systems above tested at 35psi +/- 5 psi, pH of 7.5 +/- 0.5,
Capacity Testing Flow Rate = 50% of the rated service ow rate for the various size systems.
These water softener systems have been tested by WQA and conform to NSF/ANSI 44 for specic
performance claims as veried and substantiated by test data. The rated salt efciencies above were also
determined in accordance with NSF/ANSI 44 and are only valid at the salt dosage referenced above. An
efciency rated water softener is a demand initiated regeneration (DIR) softener which also complies with
specic performance specications intended to minimize the amount of regenerant brine and water used
in its operation. Efciency rated water softeners shall have a rated salt efciency of not less that 3350
grains of total hardness exchanged per pound of salt (based on NaCl equivalency) (477 grams of total
hardness exchanged per kilogram of salt), and shall not deliver more salt than its listed rating. The rated
efciency of the water softener, the salt dosage at that efciency, the capacity at that salt dosage and
that of the efciency is only valid at the stated salt dosage. Efciency is measured by a laboratory test
described in NSF/ANSI 44. The test represents the maximum possible efciency the system can achieve.
Operational efciency is the actual efciency achieved after the system has been installed. It is typically
less than the efciency due to individual application factors including water hardness, water usage, and
other contaminants that reduce the water softener’s capacity. These systems are not intended to be used
for treating water that is microbiologically unsafe or of unknown quality without adequate disinfection before
or after the system. Refer to the system Installation and Service Manals for set-up and programming
instructions.
Contact your local dealer for parts and service. See your owner’s manual for warranty information.
Important Notice: For conditions of use, health claims certied by the California Department of Public
Health and replacement parts, see product data sheet
Iowa Requirement:
Seller: ________________________________________________ Date: _________________________
Buyer: ________________________________________________ Date: _________________________
Tested and Certied
by WQA to NSF/ANSI
Standard 44 & 372 for
softener performance
& lead free compliance
and CSA B483.1.
OMNIFILTER
13845 Bishops Dr., Suite 200
Brookeld, WI 53005
PH: (800) 279-9404
OM26K • 19

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Pentair OMNIFILTER OM26K and is the answer not in the manual?

Pentair OMNIFILTER OM26K Specifications

General IconGeneral
BrandPentair
ModelOMNIFILTER OM26K
CategoryWater Dispenser
LanguageEnglish

Related product manuals