62
SunTouch Pool and Spa Control System Installation and User’s Guide
6. Configuring the heater system options Pool/Spa mode (page 14)
Set the type of heat source being used (Heater, Solar, Solar Preferred).
7. Configure the QuickTouch wireless remote buttons (page 28)
Assign four circuits to the QuickTouch remote buttons. Once you have checked that all buttons operate
properly, place labels on remote buttons.
8. Schedule on/off times for circuit (page 17)
Set times for automatic circuit activation. Up to 6 total programs can be created for all circuits combined.
One circuit can have up to a maximum of 4 programs (4/4). All user created programs are active all the time;
so check that there are not conflicting automated times.
To Next Page
Loading...
