150
5
Function Reference
Using the Built-in Flash
You can change the flash output in a range of –2.0 to +1.0. The Flash
Compensation values are as follows for 1/2 EV and 1/3 EV.
* Set interval of steps in [Expsr Setting Steps] in the [A Custom Setting] menu.
(p.144)
Set in [Flash Exp. Comp.] in the [A Rec. Mode] menu. (p.100)
Compensating Flash Output
Step interval Flash Compensation
1/2 EV –2.0, –1.5, –1.0, –0.5, 0.0, +0.5, +1.0
1/3 EV –2.0, –1.7, –1.3, –1.0, –0.7, –0.3, 0.0, +0.3, +0.7, +1.0
• m blinks in the viewfinder when the flash pops up during Flash
Compensation. (p.20)
• If the maximum flash output is exceeded when corrected to the plus (+) side,
no compensation will be effective.
• Compensating to the minus (–) side may not effect the image if the subject is
too close, aperture is low or sensitivity is high.
• This flash compensation is also effective for external flash units which
support P-TTL auto flash mode.
1.0
0.5
0.5
0.0
Swtch dst msr pt
Rec. Mode
Auto Bracket
AE Metering
AF Mode
Flash Exp. Comp.
OK
Cancel
OK
To Next Page
Loading...
Need help?
General
