Need help?Do you have a question about the Pentax K10D 76830 and is the answer not in the manual?
General| Model | K10D |
|---|---|
| Category | Digital Camera |
| Camera type | DSLR |
| Effective Pixels | 10.2 MP |
| Sensor Type | CCD |
| Sensor Size | 23.5 x 15.7 mm |
| Image Processor | PRIME (Pentax Real Image Engine) |
| Continuous Shooting Speed | 3 fps |
| Built-in Flash | Yes |
| Flash Sync Speed | 1/180 sec |
| Storage Media | SD/SDHC |
| Weather Sealing | Yes |
| Lens mount | Pentax KAF2 |
| ISO Range | 100-1600 |
| Shutter Speed | 30 - 1/4000 sec |
| LCD Screen | 2.5 inch |
| Viewfinder | Pentaprism |
| Autofocus | SAFOX VIII |
| Battery | D-LI50 |
| Dimensions | 70 mm |
Steps for preparing the camera for adjustment procedures.
List of necessary hardware and software for adjustment.
Instructions for preparing SD cards for firmware updates and data writing.
Procedures for setting up the computer and copying software to SD cards.
List of tools needed for light source calibration.
Configuring the computer for the calibration process.
Detailed steps for calibrating the light source.
Important safety and handling precautions for assembly/disassembly.
Visual guide for the adjustment process after replacing T100.
Procedures for disassembling the main camera body.
Steps for disassembling the front housing block.
Specific steps for the front housing block.
Procedures for the M1 component.
Procedure for positioning the first mirror.
Procedure for positioning the second mirror.
Steps to adjust viewfinder parallax.
Procedures for installing the SI block.
Steps for positioning the 0-0100 display.
Procedures for installing the 0-M100 component.
Procedures for assembling the shutter block.
Steps for assembling the battery chamber and related parts.
Procedures for handling and assembling the SR/CCD block.
Initial setup steps before camera initialization.
Procedure for installing the camera firmware.
Step-by-step guide for performing SR unit adjustment.
Confirming the correct positioning of the 0-J100 component.
Checking the sealing of the front and back side electric dials.
Steps for assembling the front cover (A150).
Steps for assembling the back cover (A201).
Procedures for installing components onto the top cover.
Measuring battery current consumption in various modes.
Checking autofocus and superimpose (SI) functions.
Verifying exposure modes and shutter release.
Pre-adjustment steps for SLR operation.
Steps for adjusting the CCD position.
Checking and confirming battery level settings.
Steps to perform SR gain adjustment.
Configuring computer and light source for digital adjustment.
Confirming the Shake Reduction (SR) function.
Procedures for setting the camera to default settings.
Table detailing battery current consumption.
To Next Page
