24
8. [ADJ] AF Joint stroke
[Required equipment] Vernier calipers
① Set the AF lever (0-A115) to the AF.C position.
② AF coupler(0-S300) must be projected from
the mount surface by 1.2mm or more.
③ When the mount lock pin comes to the mount surface
with depressing the mount lock lever, the AF coupler
must not be projected out of the mount surface.
④ Adjust 0-A121 by turning an eccentric screw,
and apply the screw lock.
9. L2 and 0-L3
[Caution] Confirm there is neither dust nor scratch on L2 and 0-L3.
① M3
② 0-L3
③ Tighten M16 (Adjustment screw) temporary
while pushing 0-L3 front side.
④ Down the focusing screen frame (0-M4) by releasing the hook portion.
⑤ Push the arrow part in figure and install M22.
In the case of temporary adjustment, Using with the M22-00E(0.35).
⑥Put the focusing screen (L2) on the frame and then push it back until it locks in place.
10. M301
① Eyepiece (M301,L7 and other)
② TY-CNL-D1.7x4.0（x2）
To Next Page
Loading...
Need help?
General
