Pentax K10D 76830 - Digital Adjustment Error Codes

63
Table of Error Code (SR Gain adjustment)
When adjustment error is occurred, below screen will be displayed.
[Table of Error Code for Gain adjustment] (aa-bb-xx)
7683
“bb-xx”
p
ture check
(
X axis
)
”と
同
じ
“bb-xx”は“01
(
aa
)
Initial ca
p
ture check
(
X axis
)
”と
同
じ
“bb-xx”は“01
(
aa
)
Initial ca
p
ture check
(
X axis
)
”と
同
じ
00 initialization 01 Read configuration file 01 Can't found setting file.
01 Can't Power on
02 Initialize USB 02, 03 Command error (Communication error)
04 Can't use this program (This program for another model)
03 Initial setting xx Command error (Communication error)
01 Initial capture check (X axis) 01-06 Command error (Communication error)
07 SW error (Manual mode)
08-10 Command error (Communication error)
01 Initial setting 11 SW error (MF mode)
12 Command error (Communication error)
13 SW error (SR SW)
14 Command error (Communication error)
02 Config setting xx Command error (Communication error)
03 Set initial data xx Command error (Communication error)
04 Read initial data 01 Command error (Communication error)
05 Set ram data for SR xx Command error (Communication error)
06 Camera release xx Command error (Communication error)
07 Get capture data 01, 02 Command error (Communication error)
03 Can't display capture image
01 Initial image is out of spec (X axis)
08 Display capture data 02 Check image is out of spec (X axis)
03 Initial image is out of spec (Y axis)
04 Check image is out of spec (Y axis)
02 Sensitivity Adjustment (Gyro X) 01 Set initial data xx Command error (Communication error)
02 Get gyro position data (X data) xx Command error (Communication error)
03 Calculate 01 Gyro wave data is something wrong (X data)
02 Gyro wave data is something wrong (Y data)
04 Write gyro sensitivity data (X axis) xx Command error (Communication error)
03 Capture check (X axis)
04 Prepare to remove USB 01 USB clear up xx Command error (Communication error)
05 initialization 01 Can't Power on
02 Initialize USB 02, 03 Command error (Communication error)
04 Can't use this program (This program for another model)
03 Initial setting xx Command error (Communication error)
06 Initial capture check (Y axis)
07 Sensitivity Adjustment (Gyro Y) 01 Set initial data xx Command error (Communication error)
02 Get gyro position data (X data) xx Command error (Communication error)
03 Calculate 01 Gyro wave data is something wrong (X data)
02 Gyro wave data is something wrong (Y data)
04 Write gyro sensitivity data (X axis) xx Command error (Communication error)
08 Capture check (Y axis)
09 Prepare to remove USB 01 USB clear up xx Command error (Communication error)
(aa) (xx)(bb)
“bb - xx” is same as a table of “01(aa) Initial capture check (X axis)”.
“bb - xx” is same as a table of “01(aa) Initial capture check (X axis)”.
“bb - xx” is same as a table of “01(aa) Initial capture check (X axis)”.
[bb-xx] is the same as “01(aa) Initial capture check (X axis)”
[bb-xx] is the same as “01(aa) Initial capture check (X axis)”
[bb-xx] is the same as “01(aa) Initial capture check (X axis)”