Pentax Optio 60 - Selecting Metering Mode

EN-37
Selecting the Metering Mode
You can select the metering mode that sets which part of the subject to measure to determine the
exposure.
1. Rotate the mode dial to
, , , or and turn your
camera on by pressing the
button.
2. Press the MENU button, then use  to select the [Mode2] menu.
3. Use  to select [AE Metering], then press the
button.
4. Use  or  to select the desired metering mode, then press the
button.
 [
Center-Weighted]: Averages the light metered from the
entire frame, but gives greater weight to the subject matter
at the center.
 [ Spot]: The exposure is determined by the small area in
the center of the screen only.
5. To exit the menu, press the MENU button.
6. Compose your subject within the focus frame.
7. Press the shutter button to capture the image.
OK: Exit :
Mode1 Mode2 Mode3
Drive Mode
AE Metering
1 / 4
Digital Zoom On
Instant Review Off
OK : Exit :
AE Metering
Center-Weighted
Spot
1 / 2