Pentax Optio A20 - Using the Remote Control Unit (Optional)

74
Taking Pictures
4
You can switch the Drive mode to Remote Control mode and take pictures using
the remote control unit E or F (optional).
1 Press the four-way controller (2) in Capture mode.
2 Press the four-way controller
(45) to select i (Remote
control) or h(0 sec remote
control).
3 Press the OK button.
The self-timer lamp blinks slowly and the
camera is ready for taking pictures.
4 Press the shutter release button on the remote control
unit.
i (Remote control) : The picture is taken after the self-timer
lamp blinks quickly for about three
seconds.
h (0 sec remote control) : The picture is taken immediately.
Using the Remote Control Unit (optional)
Taking Pictures Using the Remote Control
• Focusing may be compromised if you move the camera while the
self-timer lamp is blinking.
• You cannot use the remote control unit in Movie mode.
Shutter release button
Zoom button
Remote control unit E
(Remote control unit F
has no zoom button.)
Four-way
controller
OK button
OK
OK
OK
OK
Drive Mode
Drive Mode
0 sec remote control
0 sec remote control
Drive Mode
0 sec remote control