17
Getting Started
1
Use the battery charger to charge the battery before installing it in the
camera for the first time or after a long period of non-use, or when the
message [Battery depleted] appears.
Note: AC plug cord “Listed, Type SPT-2 or NISPT-2, 18/2 flexible
cord, rated 125 V, 7A, minimum 6ft (1.8m)”
1 Connect the AC plug cord to the battery charger D-BC8.
2 Plug the AC plug cord into the power outlet.
3 Place the battery in the charger so that the PENTAX
logo is visible.
The charging indicator lights red while the battery is charging. It lights
green when charging is finished.
4 Remove the battery from the battery charger when
charging is finished.
Charging the Battery
• The time required to fully charge the battery is about 100 minutes
(max.). The appropriate ambient temperature for charging the
battery is 0°C to 40°C (32°F to 104°F). (The charging time may vary
depending on the ambient temperature and charging conditions.)
• The battery has reached the end of its service life if it runs down
soon after being charged. Replace with a new battery.
• Do not use the battery charger D-BC8 to charge batteries other
than D-LI8 rechargeable lithium-ion batteries, as the charger may
overheat or be damaged.
• If the battery is inserted correctly but the charging indicator fails to
light, the battery may be faulty. Replace it with a new battery.
To power outlet
Charging indicator
AC plug cord
1
2
Battery charger
3
While charging:
Lights red
Charging finished:
Lights green
Downloaded From camera-usermanual.com Pentax Manuals
To Next Page
Loading...
Need help?
General
