Pentax OPTIO MX - Changing the USB Connection Mode

128
9
Settings
Choose the appropriate USB connection mode depending on whether
you are going to connect the USB cable to a printer or a computer.
1 Select [USB Connection] on the [B Set-up] menu.
2 Use the four-way controller ( 45 )
to select [PC], [PictBridge] or
[PC-F].
[PictBridge]: Select this option when
connecting the camera directly
to a PictBridge-compatible
printer.
[PC] : Select this option when
connecting the camera to a computer.
[PC-F] : Select this option if data transfer does not work properly
when [PC] has been selected.
3 Press the OK button.
The camera is ready to be connected to the computer or printer.
Changing the USB Connection Mode
• Do not connect the camera to your PC while [PictBridge] is
selected for the USB connection mode.
• Do not connect the camera to the printer while [PC] or [PC-F] is
selected for the USB Connection mode.
• Refer to the “PC Guide - Enjoying Your Digital Camera Images On
Your PC” for instructions on connecting the camera to a computer.
• Depending on the connecting condition of PC and the camera,
images or other data may not be transferred properly. If this
happens, select [PC-F]. (Data transfer is fixed at USB1.1 when
[PC-F] has been selected.)
Rec. Mode
MENU
Recorded Pixels
Quality Level
White Balance
Focusing Area
AE Metering
Sensitivity
AWB
2048
AUTO
Exit
OK
OK
MENU
How to recall the [B Set-up] menu
MENU button
Four-way controller
OK button
MENU
PCPC
NTSCNTSC
Set-up
Screen Setting
Brightness Level
Video Out
USB Connection
Sleep Timeout
Auto Power Off
1min1min
3 min 3 min
Exit
OK
OK
e_kb353.book Page 128 Monday, May 31, 2004 3:05 PM