40
2
Quick Start
Quick Start
Taking Still Pictures
The standard procedure for taking still pictures is described below. The
flash fires automatically depending on the light conditions.
1 Press the power switch.
The camera turns on and is ready to take
still pictures. This is called Still Picture
Capture mode.
2 Confirm the subject and shooting
information on the LCD monitor.
The focus frame in the middle of the LCD
monitor indicates the zone of automatic
focusing.
You can change the captured area by pressing the Zoom/w/x button
to the left or right.
x : enlarges the subject
w : enlarges the area captured by the camera
3 Press the shutter release button halfway.
The focus frame turns green if the subject is in focus.
4 Press the shutter release button fully.
The picture is taken.
The image appears on the LCD monitor for one second (Instant Review)
and is saved to the SD Memory Card or built-in memory. (p.41)
Press the Green button to switch to the Green mode and let the
camera set all the shooting functions automatically. Selecting the
Green mode is the easiest way to ensure that pictures come out
well. (p.64)
Power switch
Shutter release button
Zoom/w/x button
14:25
09/25/2005
09/25/2005
14:25
38
38
Focus frame
To Next Page
Loading...
Need help?
General
