Pentax Program Plus - Grip Super a

GRIP SUPER A
• To remove the grip, loosen the grip mount screw fully, and
keeping the camera faced downward, slide the grip up until it
comes off.
• To mount the grip, fit the grip mount socket (on the rear side of
the grip) to the grip lug on the camera.
• Align the grip mount screw with the grip mount receptacle on
the camera, and keeping the grip pushed down as indicated by the
arrow, tighten the grip mount screw with a coin.
Note: The grip should be removed from the camera body when
using the Motor Drive A or the Winder ME II.