Pentax Program Plus User Manual

LENS MOUNTING
To mount or interchange Pentax K, Ka and Kf mount lenses
follow the steps below. (For screw mount lenses, see p. 55).
• Remove the body mount cap and the rear lens cap. If the finder
cap is still on the eyepiece, remove it, (For the finder cap, see p. 51).
• Align the red dot on the camera body with the red dot on the
lens (SeeO,©-)- Seat the lens in the body mount and turn it
clockwise until the lens locks with a click. When mounting the lens
in dim light, method (©) is recommended. This method allows lens
mounting by touch. Align the raised node on lens barrel with
the lens release by touch. Then turn and lock as above.
• To remove the lens cap, press in on the notches at both sides.
• To remove the lens, press the lens release lever toward the camera
body while turning the lens counter-clockwise.
• After removing a lens from the camera body, replace the front
and rear lens caps to protect the lens from dust and stains.
Note: Don't damage or stain the
electrical contact points on the
mount face. When they become
stained, wipe them with a clean,
dry cloth.

Pentax Program Plus Specifications

General

Lens mount	Pentax K mount
ISO range	25 - 1600
Film advance	Manual
Camera type	SLR
Exposure modes	Program, Manual
Metering	TTL, center-weighted
Flash	Hot shoe