Pentax WG-10 - Playing Back Images; Playing Back Still Pictures; To Delete the Displayed Image

149
3
Taking Pictures
Saving the Settings (Memory)
The Memory function is for saving the current camera settings when the
camera is turned off.
For some camera settings, the Memory function is always set to O (On) (the
settings are saved when the camera is turned off), while for others you can
choose on or off (to choose whether the settings are saved or not when the
camera is turned off). The items which can be set to On or Off in the Memory
function are shown in the table below. (Items not listed here are always
saved in the selected settings when the camera is turned off.)
If you select O (On), the settings will be saved in the status they were in
immediately before the camera was turned off. If you select P (Off), the settings
will be reset to the defaults when the camera is turned off. The table below also
shows whether the Memory default setting for each item is on or off.
Item Description
Default
setting
Page
Face Detection
A Face Detection mode set by using the I
button.
P p.71
Flash Mode
The flash mode set with the four-way
controller (4)
O p.108
Drive Mode
The drive mode set with the four-way
controller (2)
P
p.94 -
p.101
Focus Mode
The focus mode set with the four-way
controller (5)
P p.110
Zoom Position
The zoom position set with the w/x
button.
P p.79
MF Position
The manual focus position set with the four-
way controller (23)
P p.111
White Balance
The [White Balance] setting on the [A Rec.
Mode] menu
P p.119
Sensitivity
The [Sensitivity] setting on the [A Rec.
Mode] menu
P p.122
EV Compensation
The [EV Compensation] setting on the [A
Rec. Mode] menu
P p.124
AE Metering
The [AE Metering] setting on the [A Rec.
Mode] menu
P p.121
Digital Zoom
The [Digital Zoom] setting on the [A Rec.
Mode] menu
O p.81
DISPLAY
The display information display mode set
with the 4/W button
P p.23
File No.
If a new SD Memory Card is inserted when
On has been selected, file numbers are
assigned sequentially.
O ⎯