Pentax WG-10 - Changing the Start-up Screen

238
7
Settings
You can choose the start-up screen displayed when the camera is turned on.
You can choose any of the following images as the start-up screen:
• The Guide Display Start-up Screen showing a guide to the shooting
modes and buttons
• The pre-installed screen
• One of your own images (compatible images only)
1 In Q mode, press the four-way controller (3).
The Playback Mode Palette appears.
2 Use the four-way controller
(2345) to select ^ (Start-
up Screen).
3 Press the 4 button.
The image selection screen appears.
4 Use the four-way controller
(45) to choose the image for
the start-up screen.
Only images suitable for the start-up
screen are displayed. You can also
choose the pre-installed screen or the
Guide Display Start-up Screen already
stored in the camera.
5 Press the 4 button.
The setting is saved.
Changing the Start-up Screen
2/2
Start-up Screen
For setting a captured
image as the Start-up
Screen
OK
OK
MENU
Cancel
100
10 0
-
0017
00 17
100
-
0017
MENU
MENU
MENU
Cancel
Cancel
Cancel
OK
OK
OK
OK
OK
OK