145
3
Taking Pictures
5
Use the four-way controller
(45) to select O (On) or
P (Off).
O(On) Automatically corrects
for camera shake.
P (Off) No correction for
camera shake.
The setting is saved.
6
Press the 3 button twice.
The camera returns to capture mode.
In this mode, you can record multiple still pictures taken automatically at
a set interval from a set time, as a movie file.
1
Press the four-way controller (2) in C or mode.
2
Use the four-way controller
(45) to select k (Interval
Shoot) and press the 4
button.
The current Interval Movie setting
appears for approximately one
minute. To take pictures with the
current settings, go to step 10.
Recording a Movie from Pictures Taken at a Set
Interval (Interval Movie)
Interval You can set this to 1 minute, 5 minutes, 10 minutes, 30 minutes, or 1 hour.
Total Time
Set the total time, from 10 minutes to 359 hours. The total time and the
settable units change depending on the interval set. The Interval can be set
in increments of 1 minute, 5 minutes, 10 minutes, 30 minutes, or 1 hour.
Start Delay
Set the start delay, from 0 minutes to 24 hours. The start delay can be
set in increments of 1 minute for a delay time up to 59 minutes, and
increments of 1 hour for a delay time longer than one hour. If the start
time is set to 0 minutes, the first picture is taken as soon as the shutter
release button is pressed.
Setting from Drive Mode
MENU
Movie
Recorded Pixels
Interval Shoot
Movie SR
Drive Mode
Interval Shoot
Drive Mode
Interval Shoot
MENU
MENU
Cancel
Cancel
OK
OK
OK
OK
To Next Page
Loading...
Need help?
General
Weight and Dimensions
