6500 Series Purge and Pressurization System
I/O Manual
50
• Bluetooth settings
BLUETOOTH SETTINGS BLUETOOTH ENABLE NO, YES
BLUETOOTH ID XXXXXXXXXXXXXXXXXX
The 6500 control unit is equipped with a Bluetooth chip that allow for wireless communication. Several apps
are available on our web site www.pepperl-fuchs.com.
Note!
Compatible with Bluetooth 4.0
• System reset
SYSTEM RESET PASSWORD NO, YES
System Reset – System Reset will disconnect and connect power to the EPCU to start the system. This will
not reset any user-defined parameters.
• Factory restore
FACTORY RESTORE PASSWORD NO, YES
To implement the factory restore the bypass password is required. This will restore the 6500 system to
the factory settings. After implementing a factory restore, the unit will request to enter setup and bypass
passwords.
• Bootloader load settings
BOOTLOADER MODE PASSWORD NO, YES
Bootloader mode allows new firmware to be updated into the system. While the system is in bootload it is
important to not disconnect power. Bootloader may take up to 20 min to complete.
If the bootloader mode is initiated, and a PC not connected, an error will occur. It can be cleared only by
powering the 6500 control unit down and back up.
Instructions for bootloader will be available at www.pepperl-fuchs.com
To Next Page
Loading...
