VisuNet FLX Panel
Introduction
2021-04
7
2.5 Tolerances for Linear Dimensions
For all dimension drawings (e.g. dimension drawings, etc.) the European dimension standards
are valid.
All dimensions are in mm.
Unless otherwise specified, the following general tolerances are valid.
Nominal dimension ranges
Nominal dimension range
General tolerance according to
DIN ISO 2768 medium
up to 6 mm ± 0.1 mm
over 6 mm to 30 mm ± 0.2 mm
over 30 mm to 120 mm ± 0.3 mm
over 120 mm to 400 mm ± 0.5 mm
over 400 mm to 1000 mm ± 0.8 mm
To Next Page
Loading...