IMPORTANT SAFETY INFORMATION
WARNING
READ, UNDERSTAND AND FOLLOW ALL INSTRUCTIONS AND WARNINGS BEFORE OPERATING THIS
TOOL. FAILURE TO DO SO MAY RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE AND WILL
VOID WARRANTY.
1. Study, understand and follow all instructions
before operating this device.
2. DO NOT exceed rated capacity. Overloading
can cause damage to or failure of this
product.
3. Use only on hard, level surface capable of
sustaining the load. Use of jack on other than
hard level surfaces can result in jack instability
and possible loss of load.
4. Lifting device only. Immediately after lifting,
support the vehicle with appropriate means.
Ensure that no personnel pass underneath
load until load is securely supported by jack
stands.
5. DO NOT adjust safety valve.
6. Wear ANSI approved safety goggles and
heavy duty work gloves during use.
7. Keep clear of load while lifting and lowering.
8. Lower load slowly.
9. DO NOT use for aircraft purposes.
10. Apply parking brake and chock tires before
lifting vehicle.
11. Lift vehicle only at vehicle manufacturer
recommended lift locations.
12. Inspect before every use; do not use if parts
are loose or damaged.
13. Do not alter this product in any way.
14. Keep your work area clean and well lit.
Cluttered work areas invite accidents.
15. Keep bystanders, children, and visitors away
while operating this product. Distractions can
cause you to lose control.
16. Stay alert. Watch what you are doing, and
use common sense when operating this
product. Do not use this product while tired
or under the inuence of drugs, alcohol or
medication. A moment of inattention while
operating this product may result in serious
personal injury.
17. Store idle jacks out of reach of children and
other untrained persons. Jacks are
dangerous in the hands of untrained users.
18. Tool/equipment service must be performed
only by qualied repair personnel. Service
or maintenance performed by unqualied
personnel could result in a risk of injury.
19. When servicing this product, use only
identical replacement parts - refer to
attached, product-specic parts list and
diagram. Follow instructions in the Care
& Maintenance section of this manual. Use
of unauthorized parts or failure to follow
maintenance instructions may create a risk of
injury and may void any applicable warranty.
20. Maintain labels and nameplates on this
product. These carry important information.
If unreadable or missing, contact
Performance Tool for a replacement.
21. Before use, read manufacturer’s instruction
manual for the vehicle (or object) you will lift.
22. When lifting only one wheel, support the
load immediately with one jack stand (not
included) placed under the side of the
vehicle being lifted. Align the saddle of the
jack stand directly under the vehicle’s frame
or recommended lifting point.
23. When lifting the entire front end or rear end
of a vehicle, support the load immediately
with two jack stands. Align the saddles of the
jack stands directly under the vehicle’s frame
or recommended lifting points. Also, adjust
the jack stands to the same height.
24. Do not work under the vehicle without
properly supporting the vehicle with jack
stands.
25. Avoid dangerous oncoming trafc. Use
the Jack as far away from the roadside as
possible.
26. Industrial applications must follow OSHA
requirements.
27. Do not allow anyone inside the vehicle while
using the Jack. Keep all bystanders a safe
distance away from the vehicle.
28. Do not support both ends of the vehicle at
the same time.
29. Before lowering the jack, remove all tools
and equipment from under the vehicle.
30. The warnings, precautions, and instructions
discussed in this manual cannot cover all
possible conditions and situations that may
occur. The operator must understand that
common sense and caution are factors,
which cannot be built into this product, but
must be supplied by the operator.
Warning: This is a lifting device only. Load must be supported immediately by Jack Stands.
3
To Next Page
Loading...
Need help?
General
