62 . Clarus 590 GC User’s Guide
Editing the Active Method
If you have read and used the chapters in this manual sequentially, as recommended, by now you have
probably installed and conditioned one or two columns, and set up one or two detectors. Also, you were
probably not aware at the time that you modified certain Active Method parameters. Since the conditions
used then were not necessarily those required by the analyses you want to perform, you should now edit
the Active Method to set your operating parameters.
Examples of how to perform the tasks listed below are described in the sections which follow. You should,
of course, substitute your values for ours.
• Setting up oven temperature programs
• Setting injector temperatures/programs (PSS and POC)
• Setting detector temperatures
• Viewing/setting carrier-gas pressure/programs (PPC)
• Viewing/setting carrier-gas flow/programs (PPC)
• Setting up valves
• Setting PID, NPD, or FPD range
• Setting TCD filament current
• Routing detector output
• Attenuating detector signals
• Autozeroing a detector
• Building a timed events table
To Next Page
Loading...
Need help?
General
