09931286E
25
NOTE:
When the 6-Position Peltier Controlled Cell Changer is connected for the first time, you need to correct
the cell position. Calibrate the beam position of the 6-Position Peltier Controlled Cell Changer referring to
the chapter Calibration of Multi-Cell Position (p30).
6. Open the method in main menu or click the mode icon on the left side of the main window. Set
parameters for Experiment.
NOTE:
If you want to know about the meaning of each parameter of method tabs and other modes more
detail, please refer to X. Measurement Modes of the UV Express Software User Guide.
7. After setting parameters for Experiment, Lamp and Kinetics, click Accessory tab. Select Multi-Cell
Peltier.
To Next Page
Loading...
