Cap B
Illustration 92 g03814824
1. Loosen clip (1) and remove hose (2). Loosen clip
(3) and remove hose (4). Refer to illustration 90 .
2. Remove cap (B) from breather body (7). If
necessary, remove O ring seal (8) and discard.
3. Remove filter element (6) from breather body and
discard old filter element.
4. If necessary, install new O ring seal (8).
5. Ensure correct orientation of new filter element (6)
and install filter element in to breather body.
6. Install cap (B) hand pressure only.
7. Install hose (4) and tighten clip (3) securely . Install
hose (2) and tighten clip (1) securely.
i05970985
Grounding Stud - Inspect/
Clean/Tighten
The connection of battery cables to a battery and
the disconnection of battery cables from a battery
may cause an explosion which may result in in-
jury or death. The connection and the disconnec-
tion of other electrical equipment may also cause
an explosion which may result in injury or death.
The procedures for the connection and the dis-
connection of battery cables and other electrical
equipment should only be performed in a nonex-
plosive atmosphere.
Illustration 93 g01376112
The electronics grounding stud is located on the
upper left corner of the engine control module.
Inspect the OEM harness for good connections.
Inspect the condition of the OEM harness.
The electronics grounding stud must have a wire
ground to the battery. Tighten the electronics
grounding stud at every oil change. Ground wires
and straps should be combined at engine grounds.
All grounds should be tight and free of corrosion.
• Clean the electronics grounding stud and the
terminals for the ground strap with a clean cloth.
• If the connections are corroded, clean the
connections with a solution of baking soda and
water.
• Keep the electronics grounding stud and the strap
clean and coated with MPGM grease or petroleum
jelly.
108
SEBU9071-01
Maintenance Section
Grounding Stud - Inspect/Clean/Tighten
To Next Page
Loading...
