Perkins 854F-E34T - Injector Data Incorrect - Test

i06014480
Injector Data Incorrect - Test
This procedure covers the following codes:
Table 75
Diagnostic Trouble Codes for ““Injector Data Incorrect””
J1939 Code Description Notes
630-2 Calibration Memory : Erratic, Intermittent, or Incorrect The Electronic Control Module (ECM) detects one of the fol-
lowing conditions.
An injector code has not been programmed for one or more of
the injectors.
OR
The injector code for one or more of the injectors is invalid.
The engine may have rough running at low idle.
651-20 Engine Injector Cylinder #01 : Data Drifted High The ECM will calibrate the injector energizing times while the
engine is at low idle based on the readings from the oxygen
sensor.
If the calculated energizing times exceed the limits set by the
injector code, one of these diagnostic codes will become active
for the applicable cylinder.
651-21 Engine Injector Cylinder #01 : Data Drifted Low
652-20 Engine Injector Cylinder #02 : Data Drifted High
652-21 Engine Injector Cylinder #02 : Data Drifted Low
653-20 Engine Injector Cylinder #03 : Data Drifted High
653-21 Engine Injector Cylinder #03 : Data Drifted Low
654-20 Engine Injector Cylinder #04 : Data Drifted High
654-21 Engine Injector Cylinder #04 : Data Drifted Low
The following background information is related
to this procedure:
Injector codes are seven digit alphanumeric codes
that are supplied with each injector. The code is
printed on each injector. The code is used by the
ECM to balance the performance of the injectors.
Refer to Troubleshooting, “Injector Code - Calibrate”
for further information.
Illustration 31 g02738616
Typical example of an electronic unit injector
(1) Location of the injector code
UENR0612 147
Circuit Tests
This document has been printed from SPI2. NOT FOR RESALE