Table 36
Troubleshooting Test Steps
Values Results
1. EGR cooler
A. Check the EGR cooler for leaks for utilizing the “On Engine
Test Procedure” . Refer to Systems Operation, Testing and Ad-
justing, “Exhaust Cooler (NRS) - Test”.
EGR Cooler Result : The EGR cooler has a leak.
Repair: Replace the EGR cooler. Refer to the Disassembly
and Assembly manual for the correct procedure.
Proceed to Step 5.
Result : The EGR cooler does not have a leak.
Proceed to Test Step 2.
2. Cylinder head gasket leak
A. Check the cylinder head gasket for leaks. Refer to the Sys-
tems Operation/Testing and Adjusting for the proper procedure
for checking the cylinder head.
Cylinder Head
Gasket
Result : The cylinder head gasket is leaking.
Repair: Replace the cylinder head gasket. Refer to the Disas-
sembly and Assembly manual.
Result : The cylinder head gasket is not leaking.
Proceed to Test Step 3.
3. Cylinder head
A. Check for cracks in the cylinder head. Perform a leak test
on the cylinder head. Refer to the Systems Operation/Testing
and Adjusting for the proper procedure for checking the cylin-
der head.
Cylinder Head Result : A crack is found in the cylinder head.
Repair: Repair the cylinder head and/or replace the cylinder
head. Refer to the Disassembly and Assembly manual.
Result :There are no cracks in the cylinder head.
Contact the Dealer Solution Network (DSN).
i05874144
Exhaust System Contains Oil
Probable Causes
• Extended idle times
• Failed turbocharger seals
• Worn valve guide seals or faulty valve guide seals
• Worn valve guides
• Worn piston rings
Complete the procedure in the order in which the
steps are listed.
86 UENR0612
Symptom Troubleshooting
This document has been printed from SPI2. NOT FOR RESALE
To Next Page
Loading...
