Configuration Parameters
i05982913
Configuration Parameters
The electronic service tool can be used to view
certain parameters that can affect the
operation of the
engine. The electronic service tool can also be used
to change certain parameters. Some parameters
cannot be changed and some applications do not
allow any changes to the programmable monitoring
system. The parameters are stored in the Electronic
Control Module (ECM).
The parameters are divided into two different types:
Customer Specified Parameters – Customer
specified parameters can be changed using the
electronic service tool.
System Configuration Parameters – System
configuration parameters affect the emissions of the
engine or the power of the engine. Factory passwords
may be required to change the values of system
configuration parameters.
1. Connect to the electronic service tool.
2. Select the Service tab.
3. Select the Configuration tab to view the
configuration parameters.
If an ECM is replaced, the appropriate parameters
must be copied from the old ECM. Refer to
Troubleshooting, “ECM Software - Install” or
Troubleshooting, “ECM - Replace”.
NOTICE
Changing the parameters during engine operation
can cause the engine to operate erratically and can
cause engine damage.
Only change the settings of the parameters when the
engine is STOPPED.
22 UENR0612
Configuration Parameters
This document has been printed from SPI2. NOT FOR RESALE
To Next Page
Loading...
