Emergency Repairs
144
2. Apply a thin layer of grease to the fitting edge of the wheel hub.
3. Also apply a thin layer of grease to the fitting edge of the wheel rim. This grease
layer should prevent the wheel rim and the wheel hub from becoming "rust-
bound".
4. Check whether the contact surfaces of the wheel rim and the drum brake are
clean. Clean if necessary.
5. Clean the wheel nuts and then apply a drop of oil between the thrust washer and
the nut.
6. Also apply a drop of oil to the first turn of the wheel-stud screw threads.
7. Fit the wheel nuts and tighten them evenly according to the sequence in the
illustration.
For the specified tightening torque, see "TECHNICAL DATA".
1
1 1
7
8
2 2
5
6
34
5
3
4
6
2
3
4
5
6
7
8
9
10
D0 00 615
To Next Page
Loading...
