Seats
73
Due to these factors, the three-point safety belt system installed in your vehicle
requires thorough inspection every 20,000 miles (32,000 km). If the vehicle is
exposed to severe environmental or working conditions, more frequent inspections
may be necessary. Any seat belt system that shows cuts, fraying, extreme or
unusual wear, significant discoloration due to UV (ultraviolet) exposure, abrasion to
the seat belt webbing, or damage to the buckle, latch plate, retractor hardware or
any other obvious problem should be replaced immediately, regardless of mileage.
WARNING
It is important to remember that any time a vehicle is involved in an
accident, the entire seat belt system must be replaced. Unexposed
damage caused by the stress of an accident could prevent the
system from functioning properly the next time it is needed. Failure
to comply may result in personal injury or death.
Inspection Guidelines
Follow these guidelines when inspecting for cuts, fraying, extreme or unusual wear
of the webbing, and damage to the buckle, retractor, hardware, or other factors.
Damage to these areas indicates that belt system replacement is necessary.
WARNING
Replace the entire belt system (retractor and buckle side) if
replacement of any one part is necessary. Unexposed damage to
one or more components could prevent the system from
functioning properly the next time it is needed. Failure to comply
may result in personal injury or death.
To Next Page
Loading...
