Petsafe VT-100 - Receiver Collar LED Status and Battery Indicators; Fit the Receiver Collar

12 www.petsafe.net www.petsafe.net 13
DENL ITFR ESEN
Receiver Collar LED – Function and Response
Receiver Collar Function Green LED Response
Power on Flashes once and beeps low to high
Normal operation - Good battery 1 flash every 5 seconds
Training Tone On length of button press
Pairing Complete Flashes 5 times
Receiver Collar Function Red LED Response
Power off On for 3 seconds
Normal operation - Low battery 3 flashes every 5 seconds
Vibration Stimulation On length of button press
STEP 3
Fit the Receiver Collar
Important: The proper fit and placement of your Receiver Collar is important for
effective operation. The Vibration Points must have direct contact with your dog’s skin
on the underside of his neck.
To assure a proper fit, please follow these steps:
1. Make sure that the Receiver Collar is turned off.
2. Start with your dog standing comfortably (3A).
3. Place the Receiver Collar on your dog’s neck close to
the ears. Centre the Vibration Points underneath your
dog’s neck, touching the skin (3B). Note: It is sometimes
necessary to trim the hair around the Vibration Points to
make sure that contact is consistent.
Do not shave the pet’s neck as this may increase the risk of skin irritation.
3A
3B