PETTIBONE 8044 - Identification; Forklift Identification Plate; Engine Identification Plate; Axle Identification Plate Location

Page 46
TRAVERSE LIFT
Pettibone Michigan, L.L.C. OWNER/OPERATOR MANUAL MODELS 6036/6044/8036/8044
INTRODUCTION
The Extendo rough-terrain forklift is manufactured by Pettibone Michigan L.L.C., a subsidiary of
the Pettibone L.L.C. The Extendo is designed to provide years of reliable operation with minimal
maintenance.
IDENTIFICATION
FORKLIFT IDENTIFICATION PLATE
The forklift identification plate is located outside, on the left end of a rear frame member of
the operators compartment. It contains the equipment model number, serial number and gross
vehicle weight (GVW). (See Figure 3.)
Figure 3. Forklift Identification Plate Location
ENGINE IDENTIFICATION PLATE
The Cummins engine identification plate is located on the timing cover at the engines left front
(right side of forklift). (See Figure 4.)
TRANSMISSION IDENTIFICATION PLATE
The transmission identification plate is located atop the transmission housing, centered behind the
engine. It contains the model, specification number and serial number. (See Figure4.)
AXLE IDENTIFICATION PLATE LOCATION
FORKLIFT
IDENTIFICATION
PLATE