Page 52
TRAVERSE LIFT
Pettibone Michigan, L.L.C. OWNER/OPERATOR MANUAL MODELS 6036/6044/8036/8044
Fig. 2-2, Location of the seat adjustments.
Seat Belt
Fasten the seat belt as follows:
1. Position both belts across your lap. If latch belt
is too tight to pull, slide the latch plate up along
the belt webbing. This will provide more belt
slack.
Position the belt across your waist as low on the
hips as possible. This is necessary to spread the
force of the belt over the hipbone instead of
across the abdomen.
2. Insert latch plate into buckle until a click is
heard(See Fig. 2-3). Pull the loose end of the belt
to tighten(See Fig. 2-4). To unlock the seat belt,
press button on buckle and pull latch plate from
buckle(See Fig. 2-5).
Make sure that seat belt fits snugly across your
waist with a minimal amount of slack. If the belt
has too much slack, it may not be able to restrain
you in an accident.
Never wear a twisted seat belt.
Pettibone recommends that operators use the
seat belt at all times when driving this machine
and will not be held responsible if the operator
does not use the safety restraints available..
Fig. 2-3, Insert until it clicks into place.
Fig. 2-4, Pull loose end of belt to tighten.
Fig. 2-5, Press the button to release the belt.
To Next Page
