Mounting and commissioning the machine
8 - 7
8.06 Switching the machine on/off
● Switch the machine on (see Chapter 7.01 On/Off switch).
8.05 Commissioning the machine
● Check the machine, especially the
electrical leads, for any damage.
● Clean the machine thoroughly (see
chapter 10 Care and maintenance).
● Have specialists ensure that the
machine’s motor can be operated with
the available electricity supply and that it
is connected properly. If not, the machine
must not be operated.
● Before commissioning the machine,
remove grommet 1 of oil container 2.
Grommet 1 is only needed for
support during transportation
and must not be used while the
machine is in operation.
Fig. 8 - 08
1
2
To Next Page
Loading...
