11:2
B
A
D
Maintenance
Cleaning the machine
7RNHHS\RXUVHZLQJPDFKLQHRSHUDWLQJZHOOFOHDQLW
RIWHQ1ROXEULFDWLRQRLOLQJLVQHHGHG
Wipe the exterior surface of your machine with a soft
FORWKWRUHPRYHDQ\GXVWRUOLQWEXLOWXS
Note: Use of cleaners or solvents on the machine can cause
damage to the plexifront. Clean only with a soft dry cloth.
:LSHWKH3)$))
®
creative
™
&RORU7RXFK6FUHHQZLWKD
clean, soft and damp cloth.
Cleaning the bobbin area
Note: Lower the feed dogs by pressing presser foot up
and extra lift. Turn off the machine.
5HPRYHWKHSUHVVHUIRRWDQGVOLGHRIIWKHEREELQFRYHU
3ODFHWKHVFUHZGULYHUXQGHUWKHQHHGOHSODWHDVVKRZQLQ
WKHSLFWXUHDQGJHQWO\WXUQWKHVFUHZGULYHUWRSRSRIIWKH
QHHGOHSODWH&OHDQWKHIHHGGRJVZLWKWKHEUXVKIRXQG
with the accessories.
Cleaning under the bobbin area
&OHDQWKHDUHDXQGHUWKHEREELQFDVHDIWHUVHZLQJVHYHUDO
SURMHFWVRUDQ\WLPH\RXQRWLFHDQDFFXPXODWLRQRIOLQWLQ
the bobbin case area.
5HPRYHWKHEREELQFDVHKROGHU$FRYHULQJWKHIURQW
SDUWRIWKHEREELQFDVHE\OLIWLQJLWXS5HPRYHWKHEREELQ
FDVH%E\OLIWLQJLWXS&OHDQZLWKWKHEUXVK
Note: Use caution when cleaning around the thread
snips knife (C).
Put the bobbin case and the bobbin case holder back in
place.
Note: Do not blow air into the bobbin case area. The dust and
lint will be blown into your machine.
Note: When using the INSPIRA
™
Cutwork Needles, it is
necessary to clean the bobbin area after each embroidered
design/project.
Replacing the needle plate
With feed dogs lowered, place the needle plate with
WKHNQREÀWWLQJLQWRWKHQRWFKDWWKHEDFND3UHVVWKH
QHHGOHSODWHGRZQXQWLOLWFOLFNVLQWRSODFH6OLGHRQ
EREELQFRYHU
Non-original parts and accessories
7KHZDUUDQW\GRHVQRWFRYHUDQ\GHIHFWRUGDPDJH
FDXVHGE\XVHRIQRQRULJLQDODFFHVVRULHVRUSDUWV
C