2:7
C
D
B
A
E
C
A
Preparations
Bobbin winding
Winding from horizontal position
3ODFHDQHPSW\EREELQRQWKHEREELQZLQGHU
VSLQGOHZLWKWKHORJRIDFLQJXS8VHRQO\WKH
RULJLQDO3)$))
®
EREELQVDSSURYHGIRUWKLV
model.
3ODFHWKHWKUHDGVSRRORQWKHVSRROSLQLQ
KRUL]RQWDOSRVLWLRQ6OLGHDVSRROFDSWLJKWO\
against the spool.
3ODFHWKHWKUHDGLQWRWKHWKUHDGJXLGH$IURP
IURQWWREDFN3XOOWKHWKUHDGFRXQWHUFORFNZLVH
DERYHWKHEREELQZLQGHUWKUHDGJXLGH%DQG
WKHQWKURXJKWKHEREELQWKUHDGJXLGHV&DW
the rear.
Note: Make sure the thread is pulled securely inside
the pre-tension device for correct thread tension.
7KUHDGWKURXJKWKHVORWLQWKHEREELQ'IURP
the inside to the outside.
3XVKWKHEREELQZLQGHUOHYHUWRZDUGVWKH
EREELQWRZLQG$SRSXSDSSHDUVRQWKH
VFUHHQ7RDGMXVWZLQGLQJVSHHGXVHWKHVOLGHU
LQWKHSRSXS6WRSDQGVWDUWEREELQZLQGLQJ
ZLWKWKHLFRQVLQWKHSRSXS+ROGWKHHQGRI
WKHWKUHDGÀUPO\ZKHQVWDUWLQJWRZLQG
When the bobbin is full, the bobbin winder
OHYHUZLOOVZLWFKEDFNDQGWKHZLQGLQJZLOO
VWRSDXWRPDWLFDOO\7KHSRSXSFORVHV5HPRYH
the bobbin and cut the thread using the bobbin
WKUHDGFXWWHU&XWWKHIUHHWKUHDGHQGFORVHWR
the bobbin.
Winding while threaded
Make sure that the presser foot and the needle
DUHLQWKHXSSRVLWLRQ7RSUHYHQWWKHQHHGOHIURP
bending, pull the thread out of the needle.
%ULQJWKHWKUHDGXSIURPWKHQHHGOHWKUHDGJXLGH
(XSZDUGWKURXJKWKHOHIWKDQGWKUHDGLQJVORW
DQGWKURXJKWKHEREELQWKUHDGJXLGHV&7KHQ
IROORZVWHSDQGDERYH